How To Colour Match Paint for Blemishes On Your Walls
In some cases, wall paint gets damaged or dinged and afterwards, you have to go about fixing the walls. After you have repaired a hole in the wall, you certainly have to repaint the location that was damaged. However, you repainted that wall surface over one decade earlier and you can’t remember the precise paint colour match for the wall to touch it up. Most of the wall surfaces are drywall and the older residences of plaster. So, there is generally a means to get this paint on the walls matched.
Here are some tips to help get that paint colour matched
STEP 1: Find the Leftover Paint Can
Most obviously, check your basement or garage for the remaining paint. Sometimes you have stored it but may have forgotten about it. Ideally, the paint cover was labelled too to aid you to narrow down where the previous colour code or where it was purchased.
Step 2: Determine the Finish Paint
If you don’t have the leftover paint from before, you’re going to need to get a sample from the area. First, you need to determine the finish of the wall paint that you originally used. If you don’t do this, even if you get the right colour for the wall, the paint will not match. See the different finishes below:
Flat: The dullest paint finish. No sheen/shine.
Eggshell / Low Gloss: Halfway between satin and flat paint. It is a little glossy but not too shiny. You may be able to see tiny surface imperfections in the light.
Satin: Shinier than eggshell paint, but less than a semi-gloss paint. The surface reflects some light and is more washable than eggshell.
Semi-Gloss: A finish with a noticeable amount of gloss and sheen. Highly washable finish. It will show surface imperfections when washed.
Gloss: This finish has the most gloss and sheen. I have the appearance of a glass or ceramic finish.
STEP 3: Retrieve A Paint Sample From The Wall
After you have actually established the finish of your wall paint, you will require to obtain a sample of the paint colour that is on your wall.
Find a hidden spot on the wall that you can cut into.
Using a sharp knife cut into the wall. You will need to make a 2” by 2” square.
Make sure to cut deep enough that the square won’t break when you are peeling it off the wall.
Peel from the left corner to the down to the right corner. Be careful, as you don’t want to break the sample.
STEP 4: Bring Your Sample To A Professional
Once you have your sample in hand, bring it to your local hardware store or any other paint store in Edmonton and give it to the paint colour specialist.
Most paint experts have machines that should be able to tell you that paint code or something very close to it. They should also be able to tell you the shine or sheen by eye.
Make sure to keep your sample in an envelope or plastic bag so it doesn’t get damaged or lost on the way.
Step 5: If It Can’t Be A Perfect Colour Match
There are often rare situations when the paint store is not able to do a paint colour match flawlessly for their client. Realize that this does occur occasionally, specifically with brighter, deep, as well as neon colours. If it does happen to you, you will have to paint the whole wall surface or location with colour near to it. The most effective thing to do is bring your wall cut out to a paint store and look at their colour pallets as well as examples on screen. If this isn’t practical, then get a huge wall surface paint colour fan deck and bring it to your house to attempt to match. It’s best to do this in daylight when the light in the space is the brightest.
If you have followed every one of the steps properly, you should have a paint colour matching your initial wall colour.
We are professional interior house painters and do much more than just helping with your colour match projects.